165
Appendix
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the CEC
battery charging testing mode is activated, all telephone functions, except handset battery charging,
will be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged
with charged batteries before proceeding.
2. While you press and hold /HANDSET LOCATOR, plug the telephone base power adapter back to
the power outlet.
3. After about 20 seconds, when the HOME light starts flashing, release /HANDSET LOCATOR and
then press it again within two seconds. You hear a confirmation tone. The HOME light turns off and all
handsets display To register, see user manual. Allow up to one minute for the process to complete.
If the phone fails to enter this mode, repeat Step 1 through Step 3.
The telephone base will be powered up as normal if you fail to press /HANDSET LOCATOR
within
two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The telephone
base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 129-130 for handset registration
instructions.
BC
To Next Page
Loading...
