76
Multiple handset use
Push-to-talk (PTT)
You can directly broadcast messages to the speakerphone of any
device. Press and hold PUSH TO TALK on a handset or PTT/FLASH
on the telephone base to begin two-way communication.
Only one device can talk at a time. While talking to another
device, press and hold PUSH TO TALK on the handset or
PTT/FLASH on the telephone base.
You must release PUSH TO TALK on the handset or PTT/FLASH
on the telephone base, so the other person can respond.
Only one PTT session can be active at a time.
While PTT is in use between two devices, other devices cannot
use the intercom feature but can access the answering system.
When you attempt to place a PTT call to another device which is accessing
the answering system or on an intercom call or outside call, your device
screen shows Not available at this time.
NOTE: The PTT function is not available when QUIET mode is on.
Turn PTT incoming signal on or off
You can turn PTT incoming signal on or off on each handset or the telephone base.
When PTT incoming signal is on, the handset can begin and
receive PTT calls.
When PTT incoming signal is off, the handset can begin PTT
calls but will not receive PTT calls from other handset(s).
The idle handset displays No Incoming PTT. The idle
telephone base displays No PTT call.
To turn on or off the PTT incoming signal:
Press PUSH TO TALK on the handset or press PTT/FLASH
on the telephone base in idle mode.
Press CID or DIR to highlight PTT On/Off, then press SELECT .
Press CID or DIR to highlight On or Off, then press SELECT.
NOTE: When you attempt to place a PTT call to handsets or telephone base that have the PTT
incoming signal turned off, the screen displays Not available at this time.
•
•
•
•
•
•
•
1.
2.
3.
PUSH TO TALK
HANDSET 3
Group
PTT On/Off
BACK
SELECT
INCOMING PTT
On
Off
BACK
SELECT
To Next Page
Loading...
