AT&T TL96456 - Make, Answer or End a Cell Call

52
Telephone operation
Telephone operation
Make, answer or end a cell call
The TL96276/TL96456 can be used to make or answer calls on the cell line.
You can connect a maximum of two Bluetooth enabled cell phones to the
telephone base. Both cell phones can be used on cell calls at the same time.
Using a handset:
To make a cell call:
Press CELL 1 or CELL 2. Enter the telephone number, then press DIAL.
To predial a cell call:
Enter the telephone number, then press CELL 1 or CELL 2.
To answer a cell call:
Press HOME/FLASH, /SPEAKER, CELL 1, CELL 2 or any dialing key
(0-9 or TONE ).
To end a cell call:
Press OFF/CANCEL, or put the handset in the telephone base or charger.
Using the telephone base:
To make a cell call:
Press CELL 1 or CELL 2. Enter the telephone number, then press DIAL.
To predial a cell call:
Enter the telephone number, then press CELL 1 or CELL 2.
To answer a cell call:
Press HOME, CELL 1, CELL 2 or any dialing key (0-9 or TONE ).
To end a cell call:
Press CELL 1 or CELL 2.
NOTES:
You can also use your cell phone to answer the call. If you answer with your cell phone, it
disconnects from the telephone base.
If you do not want to answer the call, press REJECT.
When you try to make a cell call but your cell phone is not connected to the base, the
telephone base displays Cellular phone not connected. Please connect to proceed.. Refer to
Bluetooth connection from idle mode on page 24 and Connect/disconnect an active device
on page 25.
Make a cell call using the cell lines of your telephone system instead of the remote voice
control feature, if you need to press dialing keys (0-9, TONE , QUIET
#
) during a call.
•
•
•
•
•
•
•
•
•
•
•
•