39
Telephone settings
Handset and telephone base settings
Set date and time
The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are set
automatically with each incoming call. If you do not want to set the date and
time automatically with caller ID information, turn this feature off (see Use
caller ID to automatically set date and time on page 44). However, the year
must be correct so that the day of the week can be calculated from the caller
ID information.
After handset registration or a power failure, the handset or telephone base
will prompt you to set the date and time.
To set the date and time manually:
Press MENU in idle mode.
Press CID or DIR to highlight Set date/time, then
press SELECT.
Press CID or DIR to select the month, then press NEXT, or
enter the 2-digit number using the dialing keys.
Press CID or DIR to select the day, then press NEXT,
or enter the 2-digit number using the dialing keys.
Press CID or DIR to select the year, or enter the 2-digit
number using the dialing keys, then press NEXT to move
on to set the time.
Press CID or DIR to select the hour, then press SAVE, or
enter the 2-digit number using the dialing keys.
Press CID or DIR to select the minute, then press SAVE,
or enter the 2-digit number using the dialing keys.
Press CID or DIR to highlight AM or PM, or press
2 for AM or 7 for PM, then press SAVE to confirm. You
hear a confirmation tone and the screen returns to the
previous menu.
NOTE: If the date and time are not set when a message is recorded, the system announces,
“Time and day not set,” before each message plays.
1.
2.
3.
4.
5.
6.
7.
8.
SET DATE
09/30/16
MM/DD/YY
BACK NEXT
SET TIME
05:41 PM
BACK SAVE
SET TIME
05:41PM
BACK
SAVE
SET DATE
09/30/16
MM/DD/YY
BACK
NEXT
To Next Page
Loading...
