25
Bluetooth
Bluetooth setup
Device list and connection
Up to four devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected and in
an active slot (D1: or D2:) on the device list. Both active devices can be on a
call at a time.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE:
When connecting a Bluetooth device to the device list, all connected devices will be
temporarily disconnected until the procedure is complete. It may take up to two minutes
to reconnect.
Review the device list
Press MENU on the telephone base in idle mode.
Press CID or DIR to highlight Bluetooth, then
press SELECT.
Press CID or DIR to highlight Device list, then
press SELECT.
Connect/disconnect an active device
While in the active device list, you may connect or disconnect your
active device.
Press MENU on the telephone base in idle mode.
Press CID or DIR to highlight Bluetooth, then
press SELECT.
Press CID or DIR to highlight Device list, then
press SELECT.
Press CID or DIR to highlight a device, then press OPTION.
Press
CID or DIR
to highlight Connect/Disconnect (whichever is
applicable), then press SELECT to confirm. The telephone base displays
Device connected/Device disconnected. You hear a confirmation tone.
NOTE: When your active device is connected, you are prompted to select Disconnect. When
your active device is disconnected, you are prompted to select Connect.
1.
2.
3.
1.
2.
3.
4.
5.
DEVICE LIST
D1:Cell Phone X
D2:Headset Y
Cell Phone Z
BACK OPTION
Cell Phone X
Disconnect
Remove
BACK SELECT
To Next Page
Loading...
