AT&T TL96456 - Page 77

70
Multiple handset use
Intercom
Using the telephone base:
Press MENU in idle mode.
Press CID or DIR to highlight Intercom, then press SELECT .
If you have one handset and no other registered device, the telephone
base displays Calling HANDSET 1.
If you have other registered device(s) or more than one handset, the
telephone base displays INTERCOM TO: and a list of registered devices.
Press CID or DIR to highlight a destination device or all devices, then
press SELECT.
-OR-
Use the dialing keys to enter a specific device number (1-9 for
handset 1-9, TONE followed by 0-2 for handset 10-12, or # for a
single headset/speakerphone, # followed by 1 or 2 for headset/
speakerphone 1 or 2, or TONE followed by # for all devices).
The telephone base displays Calling HANDSET X, Calling headset or
Calling all. The destination handset(s) rings and shows Base 0 is calling or
Base 0 is calling all (HANDSET represents the handset name, X represents
the handset number).
NOTES:
You can cancel the intercom call before it is answered by pressing OFF/CANCEL on the
handset, or by pressing END or CANCEL on the telephone base.
If you are calling all handsets, only the first handset to pick up can answer the intercom call.
If the destination device does not answer the intercom call within 100 seconds, or if the device
is in use, on a call, or out of range, the initiating device displays No answer. Try again. and
returns to idle mode.
To temporarily silence the intercom ringer, press MUTE, OFF/CANCEL or MUTE/DELETE on
the handset, or press MUTE, CANCEL or MUTE on the telephone base.
You can only use one pair of devices at a time to make intercom calls.
1.
2.
•
•


•
•
•
•
•