78
Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
If you have one handset, press and hold PTT/FLASH in idle mode.
If you have more than one handset, press PTT/FLASH in idle mode:
Use the dialing keys to enter the destination handset number (1-9 for
handsets 1-9, TONE and 0 for handset 10, TONE and 1 for handset
11 or TONE and 2 for handset 12).
-OR-
Press CID or DIR to scroll to the destination device, then press
SELECT or PTT/FLASH.
Your telephone base displays Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset number)
for a few seconds. When the connection is made, both the telephone base
and the destination handset display Press and hold [PTT] to talk and beep
once.
Press and hold
PTT/FLASH
. A chirp indicates your microphone is on. Speak
towards the telephone base. Your voice is broadcast to the destination
handset. While you are speaking, the telephone base displays PTT To
HANDSET X (X represents the destination handset number).
Release
PTT/FLASH
after speaking. Both devices beep once again and the
screens show Press and hold [PTT] to talk, then you can press and hold
PTT/FLASH
to continue speaking or the destination handsets can respond (see
Answer a PTT call on page 81).
To end the PTT call, press CANCEL or END. The telephone base shows Push
to talk Ended for a few seconds.
NOTE: After PTT/FLASH is released, the PTT call remains open for a short time. If no one
presses PTT/FLASH within 10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.
To Next Page
Loading...
