80
Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
You have two ways to call multiple handsets. When the telephone base is
not in use:
Press and hold PTT/FLASH until the telephone base shows Connecting to
group....
-OR-
Press PTT/FLASH in idle mode. Press CID or DIR to highlight Group, then
press SELECT or PTT/FLASH.
Your telephone base displays Connecting to group... for a few seconds.
When the connection is made, the telephone base and all destination
handsets display Press and hold [PTT] to talk and beep once.
Press and hold PTT/FLASH on the telephone base. A chirp indicates your
microphone is on. Speak towards the telephone base. Your voice is broadcast
to all devices.
Release PTT/FLASH after speaking. All devices beep once again. After the
telephone base beeps, you can press and hold PTT/FLASH to continue
speaking or the destination handsets can respond (see Answer a PTT call
on page 81).
Press
CANCEL
or END to end the PTT call. All devices display Push to talk
Ended for a few seconds.
NOTE: After PTT/FLASH is released, the PTT call remains open for a short time. If no one
presses PTT/FLASH within 10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.
To Next Page
Loading...
