ATEL V810 Series
V810A and V810AD Data User Manual
V6.9, July 17, 2023
1. LCD Display
Displays various menus with V810A/V810AD information such as Home, IMEI, Wi-Fi login
information (SSID and password), and Online Portal login information.
2. Power Button
Power the V810A/V810AD on/off by pressing and holding this button (note that a long press
will boot up the device). You can also short press this button to wake up the display screen
and check device information.
3. Battery Port
This battery port is used to connect to the Ni-MH rechargeable battery pack (battery pack
may be sold separately).
4. Reset Button
Use a pin to press and hold this button for factory reset.
5. SIM Card Slot
Insert your 4FF SIM card into this spring-loaded SIM card slot. To r em ov e a SIM, press the
edge of the SIM inward and the SIM will pop outward from the slot.
6. Type C Port
Insert your USB cable to this USB-C port and plug the other end into a wall adapter for
external power.
7. Ethernet Port (RJ45)
Insert an ethernet cable to this Port and plug the other end to your computer for internet
access.
8. Antenna Connector
Install an optional antenna (may be sold separately) here to increase signal strength.
Power Management
Yo u r V810A/V810AD comes with an AC wall adapter (a Ni-MH rechargeable battery pack is
optional and can be purchased separately through ATEL USA, if it is not included with your
device). For more information, visit www.ATEL-USA.com.
During a power outage or if the wall charger is unplugged, the V810A/V810AD continues
to run off the batteries to support Ethernet functions. Note that the Hotspot Wi-Fi function
will only be available if using the wall adapter or Ni-MH rechargeable battery pack.
To Next Page
Loading...
