Atel V810A - 7. Regulatory Statements

ATEL V810 Series
V810A and V810AD Data User Manual
V6.9, July 17, 2023
33
d. Plug the battery back in and make sure it is plugged in all the way into
the port. Plug the USB cable and wall charger back into the wall outlet.
e. The device should power on once the wall charger is connected.
f. If the device is on battery only without the wall charger, please press
and hold the power button until the V810 powers on.
7. Regulatory Statements
FCC Equipment Authorization ID: XYO-V810
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
! This device may not cause harmful interference.
! This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
FCC CAUTION: Any changes or modification not expressly approved by ATEL, the party
responsible for compliance could void the user's authority to operate this equipment.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Warning Statements:
The antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons during the normal operations.
NOTE: The Radio Frequency (RF) emitter installed in your modem must not be located or
operated in conjunction with any other antenna or transmitter, unless specifically authorized
by ATEL.