ATEQ F6 Profinet Series - Page 50

49 / 75
FG_F6_PROFINET_EN_04 / 2020-06-17
Identifier N°
Meaning
Value
Dec
Hexa
357
0165
“DUMP TIME” (AUTO VOL menu)
Dump time in program selection by volume function
0 > 650 seconds
358
0166
“PRESSU. VOL” (AUTO VOL menu)
Internal volume in program selection by volume
function
0 > 9999
359
0167
“Ref. VOL.” (AUTO VOL menu)
Reference volume in program selection by volume
function
0 > 9999
360
0168
“INT REF VOL” (AUTO VOL menu)
Internal reference volume in program selection by
volume function
0 > 9999
361
0169
“INT TEST VOL” (AUTO VOL menu)
Internal test volume in program selection by volume
function
0 > 9999
362
016A
“VOL. STEP“ (AUTO VOL menu)
Volume slice in program selection by volume function
0 > 9999
363
016B
“DUMP TIME” (Sealed Diff menu)
Dump time in sealed components
0 > 650 seconds
364
016C
“DISPLAY MODE“
Leak display management
xxxx
xxx.x
xx.xx
x.xxx
0000
1000
2000
3000
366
016E
“MODE” (EXT DUMP menu)
Dump mode
Continuous
Time
0000
1000
367
016F
“Program” (DUMP OFF menu)
Program number of the dump of function
0 > 128
368
0170
“Tolerance A”
Tolerance level A for ntest cycle
0 > 100%
369
0171
“Tolerance B”
Tolerance level B for ntest cycle
0 > 100%
370
0172
“OFFSET”(TEMP.CORR. 1 menu)
Temperature correction offset
- 9999 > 9999
371
0173
“NAME:”(Units menu)
CAL unit personalization
CHAR[5]
372
0174
“BYPASS”
Bypass valve mode selection
Pre-Fill + Fill
Pre-Fill
Fill
0000
1000
2000
373
0175
“% Cut OFF”
Cut off function Percent
0 > 100%
374
0176
“ATF TIME”
Divisor time of ATF function
0 > 650 seconds
375
0177
‘IN8:”
Function attributed to the entry of the special
cycles (input 8)
Refer to the “Configurable input
values” table at the end of this
chapter
376
0178
‘IN9:”
Function attributed to the entry of the special
cycles (input 9)
Refer to the “Configurable input
values” table at the end of this
chapter
377
0179
“MEAS. START”
Waiting time for starting the measurement in burst
test
0 > 650 seconds
378
017A
“Time Adj”
Adjusting fill time (electronic regulator)
0 > 650 seconds