6.2 Before starting
Procedure
- Check the oil level, top up if necessary. See section Initial start-up.
6.3 Starting
Procedure
For the position of the air outlet valve and the drain connections, see sections Introduction
and Condensate system
Control panel Elektronikon®
Control panel Elektronikon® Graphic
Step Action
- Switch on the voltage. Check that voltage on LED (6) lights up.
- Open the air outlet valve.
- Press start button (1) on the control panel. The compressor starts running and the automatic operation
LED (8) lights up. Ten seconds after starting, the drive motor switches over from star to delta and the
compressor starts running loaded.
Instruction book
2920 7083 31 125
To Next Page
Loading...
