Manual lubrication
Manual lubrication is required if the automatic
lubrication system fails to work.
♦
Place the hydraulic breaker at a right angle on the
working tool and exert pressure.
♦
Only use chisel paste for lubrication.
♦
Put the manual grease gun on the grease nipple
of the emergency lubrication system and inject
chisel paste.
● Lubrication interval: approx. every 2 hours
● Hydraulic breaker without DustProtector:
5 to 15 strokes from the manual grease gun
● Hydraulic breaker with DustProtector:
5 to 10 strokes from the manual grease gun
Chisel paste filling device
Atlas Copco Construction Tools offers a device for
refilling empty cartridges. This can be mounted on a
15-kg or 45-kg hobbock to fill empty cartridges as
required.
500-g chisel paste cartridges
packed per 12 cartridges:
part number 3363 0912 00 for ContiLube
®
II
Manual grease gun for ContiLube
®
II cartridges:
part number 3363 0345 67
15-kg chisel paste container,
part number 3362 2639 00
Filling device for use with 15-kg containers:
part number 3363 0946 69
45-kg chisel paste container,
part number 3362 2632 75
Filling device for use with 45-kg containers:
part number 3363 0664 11
For further information, please contact the Atlas
Copco Customer Center/Dealer in your area.
© 2012 Atlas Copco Construction Tools GmbH | No. 3390 5005 01 | 2012-05-03
Original instructions
46
HB 5800, 5800 DP, 7000, 7000 DP, 10000 DPMAINTENANCE
To Next Page
Loading...
Need help?
General
