- 14 -
15 Protect the engine, alternator, air intake
filter, electrical and regulating
components, etc., to prevent moisture
ingress, e.g. when steam-cleaning.
16 When performing any operation
involving heat, flames or sparks on a
machine, the surrounding components
shall first be screened with non-
flammable material.
17 Never use a light source with open
flame for inspecting the interior of a
machine.
18 Disconnect –battery-clamp before
starting electrical servicing or welding
(evt. turn battery-switch in “off”
position).
19 When repair has been completed, the
machine shall be barred over at least
one revolution for reciprocating
machines, several revolutions for rotary
ones to ensure that there is no
mechanical interference within the
machine or driver. Check the direction
of rotation of electric motors when
starting up the machine initially and
after any alteration to the electrical
connection(s) or switch gear, to check
that the oil pump and the fan function
properly.
20 Maintenance and repair work should be
recorded in an operator’s logbook for
all machinery. Frequency and nature of
repairs can reveal unsafe conditions.
21 When hot parts have to be handled, e.g.
shrink fitting, special heat-resistant
gloves shall be used and, if required,
other body protection shall be applied.
22 When using cartridge type breathing
filter equipment, ascertain that the
correct type of cartridge is used and that
its useful service life is not surpassed.
23 Make sure that oil, solvents and other
substances likely to pollute the
environment are properly disposed of.
24 Before clearing the unit for use after
maintenance or overhaul, check that
operating pressures, temperatures and
speeds are correct and that the control
and shutdown devices function
correctly.
TOOL APPLICATIONS SAFETY
Apply the proper tool for each job. With
the knowledge of correct tool use and
knowing the limitations of tools, along
with some common sense, many accidents
can be prevented.
Special service tools are available for
specific jobs and should be used when
recommended. The use of these tools will
save time and prevent damage to parts.
To Next Page
Loading...
