- 28 -
Operating instructions
PARKING, TOWING AND LIFTING INSTRUCTIONS
Safety precautions
Attention
Uncouple vehicle.
Secure support leg(1) to support the
compressor in a level position.
Place the compressor as level as possible;
however, it can be operated temporarily in
an out-of-level position not exceeding 15°.
If the compressor is parked on sloping
ground, immobilize the compressor by
placing wheel chocks in front of or behind
the wheels.
Locate the rear-end of the compressor
upwind, away from contaminated wind-
streams and walls. Avoid recirculation of
exhaust air from the engine. This can cause
overheating and engine power decrease.
The operator is expected to
apply all relevant Safety
precautions.
Before putting the compressor
in to use, check the brake
system.
After the first 100 km travel:
Check and retighten the wheel
nuts and towbar bolts to the
specified torque. See section
Torque values.
To Next Page
Loading...
