- 44 -
CLEANING COOLERS
Keep the coolers (1) and (2) clean to
maintain the cooling efficiency.
Clean by air jet in the direction of the
arrow.
Steam cleaning in combination with a
cleansing agent may be applied (do not use
jet at max. power).
Close the service door(s).
Remove any dirt from the
coolers with a fibre brush. Never
use a wire brush or metal
objects.
To avoid damaging the coolers,
angle between jet and coolers
should be approx. 90 °.
Protect the electrical and
controlling equipment, air
filters, etc. against penetration
of moisture.
Never leave spilled liquids such
as fuel, oil, coolant and cleansing
agents in or around the
compressor.
To Next Page
Loading...
