2.5 FALLING HAZARDS
• It is recommended that anyone on the platform wears a safety harness
connected to one of the hooking points provided for this purpose on the
work platform. Only attach one harness to one hooking point.
• Check the condition of the guard rail before you use the machine.
Check that the access rail drops back correctly into closed position.
• Always keep both feet flat on the platform floor. Do not sit or climb onto the guard rails. Do not
use a ladder or climb onto any objects on the platform to reach a greater height.
• When the platform is raised, do not use the lifting structure to leave the platform.
• Do not leave or access the work platform until it is fully lowered.
• Remove all debris, grease, or any other slippery substance from shoes and from the toe-boards
and floor of the platform.
• Always face the machine when accessing or leaving the machine. Keep 3 contact points with
the machine at all times: both hands and one or both feet and one hand.
2.6 OTHER HAZARDS
• During welding operations from the platform, do not use the machine as earth.
• During welding or metal cutting operations, make sure that you protect the machine's
components from projections of fusing metal (control station, electric cables, hydraulic hoses,
cylinders, etc.). Avoid any projection on/to the machine, particularly to the fuel tank.
• DO NOT use the machine in presence of electromagnetic fields (radar, high voltage
currents…). This could damage the machine’s electronic components
To Next Page
Loading...
Need help?
General
