5- Install the flange and tighten the bolt onto the brake piston. Tighten the counternut to pull
the piston and release the brake.
Perform this operation on each hydraulic
motor on the rear axle.
6- Loosen the bypass valve on the
transmission pump by 2 turns maximum.
(Do not exceed 2 turns to prevent any
external leak).
7- Using appropriate equipment, tow the
machine only at slow speed and on
horizontal grounds.
8- Once the towing has been performed,
block the machine's wheels, remove the
flanges to restore the brakes and tighten
the by-pass valve.
9- Check the brakes by driving the machine in a slope.
10- Release the driving joystick and check the machine stop moving.
7.4 AFTER AN INCIDENT
After an incident, inspect the machine carefully and test the good working order of all controls
and safeties. See section 3.3 Only raise the platform by a metre if all the damages have been
repaired and if all the controls are operating correctly. If in doubt, contact your reseller or the
manufacturer.
To Next Page
Loading...
Need help?
General
