10- Platform rotation control:
Tilt the switch in the direction of the arrow corresponding to the desired
movement.
Refer to Section 4.4.6 – Work platform rotation.
11- Platform Up / Down levelling control:
Tilt the switch in the direction of the arrow corresponding to the desired
movement.
Refer to Section 4.4.4 – Work Platform levelling
12- Overload indicator:
This indicator flashes when the work platform’s rated capacity is exceeded.
Refer to Section 6.2 – Load control.
12- Engine fault indicator light:
This indicator flashes when switching on and should go out when the engine
starts.
When the engine is running, the light comes on steady:
• In case of malfunction of the alternator: the alternator no longer charges
the battery correctly.
• When the engine oil pressure is abnormally low or when the cooling fluid
temperature is abnormally high: SWITCH OFF the combustion engine
as soon as possible.
Refer to 4.2.3 – Combustion engine safety devices.
12- System fault / Maintenance indicator:
This light flashes slowly when a service / pre-scheduled maintenance
operation is required.
This light is on steady (and an alarm sounds) if there is a control system
fault. Refer to 6.3 – System fault.
12- Preheat indicator:
This light comes on during the preheating phase and goes off once the
engine starts.
Refer to Section 4.2 – Combustion engine operation.
13- Hourmeter:
Indicates the global operating time of the combustion engine.
To Next Page
Loading...
Need help?
General
