Atomos Shogun flame User Manual

*Subject to change without notice Atomos Shogun Flame – User Manual Edition 1: May 2016 37
LTC
If LTC is selected then Timecode will be taken in via the LTC input (refer
page 12). If no LTC signal is present the following icon is displayed
and the unit will revert to SDI/HDMI Timecode
Please note that the LTC generator needs to be set to the same frame
rate as the input video signal. If the LTC signal is looped through
to the other channel then both recordings will have synchronized
Timecode.
Record Run
WiththissettingyousetthestartingTimecodefortherstclip.The
following clips will start at the frame immediately after the out point of the
preceding clip. This will continue for all clips that follow. This is also
known as continuous Timecode.
Auto Restart
With this setting, the Timecode will be reset to the Timecode you have
denedwheneveryoupressrecord.Allyourclipswillstartwiththissame
Timecode.
To adjust the Timecode use the “+” and “-” above and below the
hour:minute:seconds sections
9. Timecode cont.

Atomos Shogun flame Specifications

General

Display resolution	1920 x 1200 pixels
Audio system	48kHz, 24-bit
Product color	Black, Yellow
USB connectivity	Yes
Video capturing speed	120 fps
BNC input ports	1
HDD size	2.5 \
HDD interface	Serial ATA
Power consumption (max)	24 W
Cables included	DC, XLR-6.3 mm

Weight and Dimensions

Weight	650 g
Dimensions (WxDxH)	214 x 45 x 127 mm