Atomos Shogun flame - Screen Lock; Timecode; Shogun Flame Info

*Subject to change without notice Atomos Shogun Flame – User Manual Edition 1: May 2016 18
Lock the Display Screen
You can lock the display of the Shogun Flame so that
no changes can be made by mistakenly touching
the screen, to lock the Shogun Flame simply short
tap the power button. The screen lock function will
simultaneously lock or unlock both Channels of the
Shogun Flame.
Short tap the power button again to unlock the unit.
The lock screen can be combined with the display off function so
that when lock is engaged the display is turned off. The Tally light on
the front of the unit will still display Rec (Red) or idle (green) status.
Locking of the display can be found in the Monitor Mode.
Timecode
TakesyoutothededicatedTimecodecongurationpage.
Refer to Page 36 of this manual for more information.
Shogun Flame Info
Showsthesoftware(rmware)versionanduniquedevice
ID (DID) of your Shogun Flame device. This will be
required to activate the Avid DNxHD / Avid DNxHR codec.
You can also check on the Atomos website to ensure you
arerunningthelatestrmware:
http://www.atomos.com/support
Remember that pressing on the Back button will always take you
back to the previous menu.
Both Channels of the Shogun Flame are activated using a single
code and this needs to be entered via Channel 1.
7. Using the Shogun Flame cont.
UNLOCKED
LOCKED
UNLOCKED
LOCKED
UNLOCKED
LOCKED