EasyManuals Logo

ATOMSTACK A5 User Manual

ATOMSTACK A5
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Shenzhen AtomStack Technologies Co., Ltd. support@atomstack3d.com
17
emits irradiation point is the center of the engraving pattern, based on
this, adjust the position of the engraved object!
D. Click "Profile Scan" button, the laser will start to scan the outer
contour of the pattern on the computer, you can change the position of the
engraved object again according to the scanned outer contour position.
Besides: You can click on the "wrap-around" button for several times until
the outer contour is at the position you want to engrave.
Picture 2.16 light laser

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ATOMSTACK A5 and is the answer not in the manual?

ATOMSTACK A5 Specifications

General IconGeneral
Engraving Accuracy0.01mm
Data Transmission MethodUSB
Engraving Area400 x 400 mm
Laser Output Power5W
Laser Protective CoverYes
Operating SoftwareLaserGRBL
Supported File FormatsBMP, JPG, PNG, DXF
Supported MaterialsWood, Leather