ATOMSTACK A5 - Table of Contents

Shenzhen AtomStack Technologies Co., Ltd. support@atomstack3d.com
2
Directory
ATOMSTACK A5
..........................................................................................................
1
0. Security Statement
.................................................................................................
3
0. 1 Laser safety............................................................................................................................ 3
0.2 Fire safety.................................................................................................................................3
0.3 Material safety......................................................................................................................... 4
0.4 Use Safety................................................................................................................................4
1. AtomStack A5 Engraver Introduction
...................................................................
5
2. Software installation and use.................................................................................6
2.1 LaserGRBL Software Installation and Use
.........................................................................
6
1. Downloading software
..............................................................................................................
6
2. installing LaerGRBL
..................................................................................................................
7
3. Adding custom buttons
：
.........................................................................................................7
4. connect laser engraving machine...........................................................................................9
5. Setting Engraving Parameters..............................................................................................11
6. Laser focus adjustment.............................................................................................................. 13
7. Positioning
................................................................................................................................
16
8. Start, Termination carving or cutting
....................................................................................
19
2.2 LightBurn Installation Tutorial
.............................................................................................
19
3. Techniques for using machines
..........................................................................
24
4. Common materials and recommended engraving and cutting parameters25
5. Common Problems Possible Causes Treatment
............................................
26