50
April 2007
e-motion™ Operating Manual - B-Level STD
MACHINE CONVERSION
PAYTABLE CONVERSION
If the machine is converted to a new paytable type,
these areas of the machine are involved.
Paytable Software
Legend Kit
Paytable Software
The paytable software EPROM, located on the
mainboard, is available in two types:
Non-Configurable (Standard Paytable)
Configurable (Selectable Paytable)
Non-configurable paytable software requires a RAM
reset and the replacement of the paytable EPROM in
order to convert the paytable.
Configurable paytable software allows the change of
paytable settings by means of a RAM reset.
Configurable paytables are not applicable in all
jurisdictions.
Button Panel Decals / Legend Foil Kit
A button panel conversion is necessary, if a new
paytable setting with different LINES and BET PER
LINES steps is used. In most cases a button panel
conversion can be done by changing the button decals.
Button decals are delivered as a legend foil kit that
consists of a group of button decals.
Use a gaspipe pliers with soft clamping to carefully
remove the button lens caps in order to convert the
button decals.
Note:
See manual "Software / Basic
Setup" for a detailed RAM
reset procedure.
To Next Page
Loading...
