51
April 2007
e-motion™ Operating Manual - B-Level STD
MACHINE CONVERSION
DENOMINATION CONVERSION
If the machine is converted to a new denomination,
these areas of the machine are involved.
Machine Configuration
Denomination Decal
Toplight
Coin In
Coin Out
Machine Configuration
The machine's denomination is set during Initial Setup.
Initial Setup is only applicable after a RAM reset.
Denomination Decal
If the denomination is changed, the denomination decal
must be changed accordingly.
Toplight
If the machine is equipped with a toplight that indi-
cates the machines denomination by its colour, the
toplight cover has to be converted.
Coin In
If a different coin is used, these three areas of the
coin in must be converted according to coin diameter,
thickness and weight.
• Coin Entry Coin Geometry
• Coin Sorting Coin Geometry
• Coin Validator (Damper Weights)
Coin Out
If a different coin is used a hopper conversion is
necessary.
If the new coin is only slightly different from that one
used before, a hopper adjustment might be sufficient.
Note:
See manual "Hopper", chapter
"part list" for details.
Note:
See manual "Software / Basic
Setup" for a detailed RAM
reset procedure.
To Next Page
Loading...
