Aube Technologies TH141A-HC-28 - Connect the Labelled Wires to the Thermostat; Wiring Diagrams

1.5 CONNECT THE LABELLED WIRES TO THE THERMOSTAT
1. Connect the system wires to the thermostat terminals according to the wiring
diagram shown
in section 1.6.
2. Make sure that the wires are pushed well back into the wall.
3. If you own a CT240 telephone controller, refer to section 6.1 for connection.
1.6 WIRING DIAGRAMS
The TH141 thermostat is compatible with most heating and air conditioning systems.
Multi-level heating
and air conditioning systems, Milivolt control heating systems, heat
pumps and baseboard heating units are not compatible with this thermostat. Baseboard
units
can be connected using a 24 V relay.
1.6.1 2-WIRE HEATING SYSTEM
1. Connect the heating relay to terminal W.
2. Connect the 24 V transformer to terminal Rh.
In this case, the order of connection is unimportant.
l r--------Rh
--J G HEATING 1--- w
Rc
y
G
X
C
4