Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
◆ -> Headlight can be aligned with bumper contour by screwing adjusting nut -1- in or out. Adjusting nut can
only be turned after removing headlight.
- -> Engage lug -1- of headlight in guide -2- in centre area.
- Align headlight with body contours (gap widths) and secure.
- -> Tighten bolts -arrows 1 ... 3-.
- Install front bumper cover.
=> General Body Repairs, Exterior; Repair Group 63; Front Bumper Front Bumper
- Following installation, adjust headlights => Page 117 .
Tightening torque
Component Nm
Headlight to lock carrier 6
2.5 - Adjusting headlights (halogen headlights)
Specifications for headlight adjustment:
=> Maintenance
Test requirement:
• Headlight range adjuster knob must be set to -0-
Audi A3 1997 ➤
Electrical system - Edition 10.2003
116 94 - Lights, Lamps, Switches - exterior
To Next Page
Loading...
