Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note:
Exclusive use is to be made for wiring harness and connector repairs of repair set VAS 1978.
-> VAS 1978 is described in detail in the enclosed operating instructions.
The repairing of open circuits and defective connectors is also explained by way of examples.
2.3 - Repairing 0.22 mm2/ 0.35 mm2 wire
Notes:
◆ The wiring harness repair set VAS 1978 contains three different repair wire cross-sections (0.5 mm2, 1.5
mm2, 4.0 mm2) and the appropriate crimp connectors.
◆ A 0.35 mm2 wire has to be repaired using a 0.5 mm2 repair wire.
◆ The repair procedure is as follows:
- -> Strip ends of 0.22 mm2/ 0.35 mm2 wire with stripping pliers VAS 1978/3 (approx. 12 ... 14 mm).
- Fold back half the stripped wire ends.
- Use stripping pliers to strip the ends of the 0.5 mm2 wire (approx. 6 ... 7 mm).
- -> Slip crimp connectors over ends of wires and crimp on both sides using crimping tool VAS 1978/1.
Notes:
◆ Take care to select the correct red crimping insert VAS 1978/24 for 0.5 mm2.
◆ Take care not to crimp insulation of wire ends.
Audi A3 1997 ➤
Electrical system - Edition 10.2003
196 97 - Wiring
To Next Page
Loading...
