Audi A3 1997 - Input Values on Dash Panel Insert Replacement

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Display on VAS 5051 following adaption:
Example:
1 - Channel 62
Value 5 saved
- Terminate function "10 - Adaption" by touching ◂ key.
3.12 - Input values on dash panel insert replacement
The following items must always be heeded on replacing dash panel insert:
Perform the following before replacing dash panel insert:
- Use measured value blocks 010...140 to read out values in old dash panel insert which have to be transferred
to new dash panel insert.
- Before replacing, note down mileage count/mileage display value in measured value block 010 (display zone
4) => Page 66 and enter when prompted.
Note:
Service display and mileage counter are adapted in miles in countries wheredistances are measured in miles.
Perform the following after replacing dash panel insert:
- Encode dash panel insert => Page 60
and
- Enter mileage => Page 81
- Enter language version for driver information system (DIS)
=> Page 80
- Correct fuel consumption indicator => Page 78 (only if fixed value changed)
- Correct fuel gauge sender resistance range => Page 87 (only if fixed value changed)
- Correct engine speed level => Page 88 (only if fixed value changed)
- Enter oil grade => Page 96
- Enter mileage since service => Page 90
- Enter days since service => Page 91
- Enter maximum mileage prior to service => Page 94
- Enter maximum time interval prior to service => Page 95
- Enter total consumption (petrol engines only) => Page 98
- Enter amount of soot in engine oil (diesel engines only)
=> Page 99
- Enter thermal load (diesel engines only) => Page 101
- Set ambient temperature display/radio clock/dash panel insert illumination configuration => Page 85
- Enter control units using drive train data bus => Page 102
- Enter control units using convenience data bus => Page 104
- Enter control units using information data bus => Page 105
and
- Perform immobilizer adaption after replacing dash panel insert
=> Page 130
- Perform matching of vehicle keys => Page 150
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
108 01 - Self-diagnosis