Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Navigation control unit - information data bus link
▪ 1 - Control unit is information data bus user
▪ 0 - Control unit with CAN capability is not information data bus
user
▪ No display - no control unit CAN capability
Telephone control unit - information data bus link
▪ 1 - Control unit is information data bus user
▪ 0 - Control unit with CAN capability is not information data bus user
▪ No display - no control unit CAN capability
symphony radio/CAN radio as of Model Year 2002 in conjunction with Highline dash panel insert -
information data bus link
▪ 1 - Control unit is information data bus user
▪ 0 - Control unit with CAN capability is not information data bus user
▪ No display - no control unit CAN capability
3.11 - Adaption
The individual functions are called up by way of the appropriate adaption channel number (=> Adaption table,
Page 72 ).
The current dash panel insert adaption values can be read out in measured value blocks 010...016 and 019.
Adaption channel Measured value block
03 011, Page 67
19 019, Page 69
30 010, Page 66
40 and 41 012, Page 67
42 and 43 013, Page 67
44 014, Page 68
45 and 46 015, Page 68
47 and 48 016, Page 68
Note:
Adaption channels 03 and 30 are only required if factory-set adaption value has been changed due to a cus‐
tomer complaint.
Up to Model Year 2001, dash panel insert adaption values for control units with CAN capability cannot be seen
from measured value blocks; they can only be read out in the appropriate adaption channel. The adaption value
is given in the appropriate adaption channel.
As of Model Year 2002, dash panel insert adaption values for control units with CAN capability can be read out
in measured value blocks 017 and 018.
Adaption channel Measured value block
60, 61 017, Page 69
62 018, Page 69
Note:
Adaption channels 60, 61 and 62 are only required if the dash panel insert uses the corresponding system bus.
Following adaption, control units using the corresponding system bus are displayed in measured value blocks
125, 132 and 140.
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
3.10 - Reading measured value block 71
To Next Page
Loading...
