Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Measured value block 022
Display group 22 ◂ Indicated on display
X X X X ◂ Display zones 1 ... 4
Number of matched keys
▪ Up to max. 8 keys
Key status OK
▪ 1 = Yes
▪ 0 = No, i.e. not possible to read formally correct trans‐
ponder fixed code (regardless of whether authorised or not)
Engine control unit response 1)
▪ 1 = Yes
▪ 0 = No, i.e. fault in engine control unit or wiring
Starting authorised
▪ 1 = Yes
▪ 0 = No, i.e. vehicle key not/incorrectly matched or engine control unit incorrectly encoded/defective
1) Depending on engine control unit, measured value block is set for 10 ... 30 s after switching off engine
and ignition to "0 = Engine control unit response no", i.e. engine control unit released and no fault present. Start
self-diagnosis again as a check => Page 140 .
Measured value block 023
Display group 23 ◂ Indicated on display
X X X - ◂ Display zones 1 ... 4
Fixed code authorised
▪ 1 = Yes
▪ 0 = No, i.e. transponder fixed code of key not au‐
thorised
Arithmetic rule in key can be overwritten
▪ 1 = No
▪ 0 = Yes
Variable code authorised
▪ 1 = Yes
▪ 0 = No, i.e. variable code not authorised (arithmetic rule for variable code in key not the same as in
dash panel insert)
5.9 - Adaption
Note:
Adaption function can only be implemented after establishing immobilizer PIN => Establishing PIN, Page
150 .
The adaption function can be used to make and save the following changes:
◆ Matching of vehicle keys => Page 150
◆ Adaption following replacement of engine control unit=>Page 157
◆ Adaption following replacement of dash panel insert => Page 156
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
5.8 - Reading measured value block 149
To Next Page
Loading...
