Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Sequence of operations
- Start immobilizer self-diagnosis => Page 140 .
-> Display on VAS 5051:
- From list -1- select diagnosis function "08 - Reading measured value block".
-> Display on VAS 5051:
1 - Enter display group
- Use keypad -2- to enter required three-digit display group number
=>List of display groups, Page 148 and confirm entry by touching Q key.
-> Display on VAS 5051:
1 - Reading measured value block
2 - Display zone 1
Display zone 2
Display zone 3
Display zone 4
3 - Display group X
Notes:
◆ Display remains blank if a display zone is not used.
◆ Proceed as follows to switch to a different display group:
Display group VAS 5051
Up Press s key
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
5.8 - Reading measured value block 147
To Next Page
Loading...
