Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Display on VAS 5051:
1 - Enter display group
- Use keypad -2- to enter required three-digit display group number
=>List of display groups, Page 173 and confirm entry by touching Q key.
-> Display on VAS 5051:
1 - Reading measured value block
2 - Display zone 1
Display zone 2
Display zone 3
Display zone 4
3 - Display group X
Notes:
◆ Display remains blank if a display zone is not used.
◆ Proceed as follows to switch to a different display group:
Display group VAS 5051
Up Press s key
Down Press t key
- Terminate function "08 - Reading measured value block" by touching◂key.
List of display groups:
Display group
number
Indicated on display
022 1 = Starting authorised
2 = Engine control unit response
3 = Key status OK
4 = Number of matched keys
023 1 = Variable code authorised
2 = Key status (transponder)
3 = Fixed code authorised
4 = Immobilizer status
024 1 = Dash panel insert disabled
time
2 = Engine control unit disabled
time
3 = Emergency release disabled
time
4 = Transponder identification
disabled time
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
6.8 - Reading measured value block 173
To Next Page
Loading...
