Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Display on VAS 5051:
1 - Reading measured value block
2 - Display zone 1
Display zone 2
Display zone 3
Display zone 4
3 - Display group X
Notes:
◆ Display remains blank if a display zone is not used.
◆ Proceed as follows to switch to a different display group:
Display group VAS 5051
Up Press s key
Down Press t key
- Terminate function "08 - Reading measured value block" by touching◂key.
List of display groups
Display group num‐
ber
Indicated on display
001 1 = Distance from rl sensor in cm
2 = Distance from rlc sensor in cm
3 = Distance from rrc sensor in cm
4 = Distance from rr sensor in cm
002 1 = Minimum distance in cm
2 = Vehicle speed km/h
3 = Warning buzzer
4 = Not used
003 1 = Supply voltage V
2 = Reverse gear
3 = Trailer
4 = Not used
004 1 = rl sensor settling time in ms
2 = rlc sensor settling time in ms
3 = rrc sensor settling time in ms
4 = rr sensor settling time in ms
Measured value block 001
Display group 1 ◂ Indicated on display
XX cm XX cm XX cm XX cm ◂ Display zones 1 ... 4
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
218 01 - Self-diagnosis
To Next Page
Loading...
