12 Multi-function steering wheel
Multi-function steering
wheel
Ho
w to use the
controls
Applies to vehicles: with multi-function steering wheel
You can use the multi-function steering wheel
to operate a number of MMI functions, adjust
the volume and switch the speech dialogue
system on/off.
Fig. 7 Driver information system
Fig. 8 Controls on the multi-function steering wheel
Important: The ignition and the MMI system
must be switched on ð page 7.
1
How to use the driver information
system
The driver information system shows informa-
tion
B
in several display tabs
A
. The driver
information system can be oper
ated using the
multi-function steering wheel:
– To switch between tabs: Press the left/right
side of the
button.
– T
o select a function: Scroll the left thumb-
wheel to the desired function.
– T
o confirm your selection: Press the left
thumbwheel.
– To scroll through lists rapidly: Scroll the
left thumbwheel quickly.
– To open/leave a submenu: Press the
but-
ton.
The equipment installed on your vehicle de-
termines which of the following tabs ar
e avail-
able:
– 1st tab: Information on car, assist systems
– 2nd tab
1)
: Warning/indicator lamps, driver
messages, speed warning
– 3rd tab: Radio/media ð page 15
– 4th tab: Telephone* ð page 13
– 5th tab: Navigation* ð page 14
2
Steering wheel button
– T
o call up the assigned function: Press the
button on the multi-function steering
wheel
.
– To change the assigned function: On the
MMI, select
MENU
button > Car > contr
ol
button Car systems* > Vehicle settings >
Steering wheel button.
3
Adjusting the volume
Y
ou can adjust the volume of an audio source
or system message (e.g. during a speech dia-
logue) directly while it is being played.
– Volume up/down: Scroll the right thumb-
wheel up/down.
– Mute: Press the right thumbwheel.
– Unmute: Scroll the right thumbwheel up or
press the right thumbwheel.
4
Switching the speech dialogue system
on/
off
– To switch on: Briefly press the
button on
the mul
ti-function steering wheel. Give a
spoken command after the beep signal.
– To switch off: Press and hold the
button
for sever
al seconds. Or: Say the command
CANCEL.
1)
The second tab is only visible if one or more warning/
indicator lamps or driver messages ar
e displayed or if
the relevant system is switched on.
To Next Page
Loading...
Need help?
General
