36 Telephone
Via the speller
Applies to vehicles: with phone pr
e-installation
Fig. 27 Entering a telephone number via the speller
for numbers
Fig. 28
Entering a telephone number via the speller
for letters
►
Select:
TEL
button > Enter number.
– T
o enter a telephone number using num-
bers: Enter a telephone number using the
speller for numbers ð Fig. 27.
– To enter a telephone number using letters:
Press the control button for A-Z. Enter a ser-
ies of letters, e.g. AUDISERVICE using the
speller for letters.
– To dial a telephone number: Select and con-
firm OK. Or: Press the control button for Di-
al. The current audio source is muted while
the connection is established.
If you have entered incorrect digits, select and
confirm . You can delete all characters en-
tered at once by turning the speller to and
pressing and holding the rotary pushbutton.
Note
You can enter D
TMF tones ("touch-tones")
using the speller while you are talking on
the phone.
Listening to voice mail messages
Applies to vehicles: with phone pr
e-installation
►
Select:
TEL
button > control button Mail-
bo
x.
– To enter the mailbox number: Select and
confirm List and select and confirm the de-
sired number. Or: Enter the mailbox number
using the speller. Select and confirm OK.
– To dial the mailbox number: Press the con-
trol button for Mailbox.
Note
– This ser
vice must be set up and activated
on your mobile network before you can
use it. For more information, contact
your service provider.
– The mailbox number depends on your
service provider.
Answering/ignoring
telephone cal
ls
Applies to vehicles: with phone pre-installation
Fig. 29 Incoming call
Important: There must be an incoming call,
an active call
, or the phone must be establish-
ing a connection.
– To answer a call: Press the control button
for Answer.
– To ignore a call: Press the control button for
Ignore.
– To end a call/cancel the dialling process:
Press the control button for End call.
To answer a further call: If you are already
talking on the phone when someone else
calls, select Answer to place the current call