List of Images
Version 1 2016-01-01 4 / 113
List of Images
Image 1: Adding Engine Oil during Endurance Races ..................................... 22
Image 2: Scheme of Cooling System ............................................................ 24
Image 3: Expansion Reservoir ...................................................................... 28
Image 4: Refuelling Coupling, Service Tool and Molykote 1292 Grease ........... 30
Image 5: Using Service Tool, Refuelling Coupling in Service Position .............. 31
Image 6: Using Service Tool, Lubricating O-rings ........................................... 31
Image 7: Refuelling Coupling and Molykote 1292 Grease .............................. 33
Image 8: Service Tool Decoupled and Unlocked ............................................. 34
Image 9: Service Tool Fitted, Locked and Open ............................................. 34
Image 10: Gearbox – FIA Homolagated Gear Ratios ...................................... 36
Image 11: Gearbox – Clutch Bleed Nipple, Oil Level Check, Inspection Openings
................................................................................................ 38
Image 12: Screw Plug, Adjustable Differential Preload .................................. 39
Image 13: Adjustable Preload ..................................................................... 39
Image 14: Push Rod Thread With Groove Marking ......................................... 51
Image 15: Lower Damper Eye in Maximum Permitted Position ....................... 51
Image 16: Characteristic Curve Front Damper 4SA 412 019 B ........................ 53
Image 17: Characteristic Curve Rear Damper 4SA 512 019 C ......................... 53
Image 18: Front Axle Brake Cooling Duct Without Blanking ........................... 61
Image 19: Front Axle Brake Cooling Duct With Blanking ................................ 61
Image 20: Rails with Ratchet and Detent Mechanism .................................... 65
Image 21: Centre Console with Button to Disengage Pedal Unit and Main Switch
to Activate Compressor .............................................................. 66
Image 22: Push Surface on the Pedal Unit Cover ........................................... 67
Image 23: The Two Possible Throttle Pedal Plate Positions ............................ 69
Image 24: Nut to Adjust Spring Preload on Throttle Pedal ............................. 70
Image 25: Standard Setting and Adjustment Direction for Spring Preload on
Throttle Pedal............................................................................ 70
Image 26: Pedal Assembly – Throttle Pedal Damper ...................................... 71
Image 27: Adjusting the Throttle Pedal Damper ........................................... 73
To Next Page
Loading...
Need help?
General
