EasyManua.ls Logo

Audi TT 2012 - Page 152

Audi TT 2012
264 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 5 0 Child S a f e t y
The tether anchors for the rear seating posi-
t ions are located on the backside of the rear
seatbacks
¢ fig. 130 .
A tether is a straight or V-shaped strap that
attaches the top part of a child restraint to
special anchorage points in the vehicle .
The purpose of the te t her is to reduce the for-
ward movemen t of t he child restra int in a
crash, in order to help reduce the risk of head
injury that could be caused by striking the ve-
hicle inter ior.
Forward facing child rest raints manufact ured
after September 1, 1999, are required by U.S.
federal regulations to comply with new child
head movement performance requirements .
These new performance requirements make a
tether necessary on most new child safety
seats .
_&. WARNING
Imprope r insta llation of child restrai nts
will increase the risk of inju ry and death in
a crash .
- Always follow the instructions provided
by the manufacturer of the ch ild re-
st raint you intend to install in your Audi.
- Improper use of child restra int anchors
(including tether anchors) can lead to in-
jury in a collision. The anchors are de-
signed to withstand on ly those loads im-
posed by cor rectly fitted child restraints.
- Never mount t wo child restraint systems
on one LATCH lower ancho r po int .
- Never att ach two child rest ra int syst ems
to one tether strap or tether anchorage.
- Never at tach a tether st rap to a tie-down
hoo k in t he luggage compartment .
- Never use child restraint tether ancho-
rages t o secure safe ty belts o r othe r
kinds of occupan t restra ints .
- Never secure or attach any luggage or
othe r items to the LATCH lowe r ancho-
rages or to t he tether anchors.
- If a t ether or other st rap is used to at-
ta ch a child rest raint to the front passen -
ger seat, make sure that it is not so
-
tight, that it causes the weight-sensing
mat to measure more we ight than is ac-
tually on the seat.
- The heavier weight registered can make
the Advanced Airbag System work as
though an adult were on the seat and de-
ploy the Advanced Airbag when it must
be suppressed causing serio us or even
fata l injury to the child.
- If you must install a rearwa rd fac ing
child safety seat on the front passenger
seat be cause of exceptional circumstan-
ces and t he
PASSENGER AIR BAG OFF
light does not come on and st ay on, im-
mediately insta ll the rear -fac ing child
safety seat in a rear seating position and
have the airbag system inspected by your
Audi dealer.
Installing the upper tether strap on the
anchorage
Fig. 1 31 Tether st rap: proper routing and mount ing
Fig. 1 32 Tether strap: proper rout ing and mount ing
Installing the tether st rap
.,. Release or deploy t he tether strap on t he
child res t raint according to the child re-
straint manufacturer's instructions .
.,. Guide the upper tether strap into the rear
cargo area
¢ fig . 132. liJ>

Table of Contents

Related product manuals