Audi TT Platform 2009 - Installation Position of Shafts and Selector Rods in Transmission; Input Shaft, Output Shaft (Pinion Shaft), Differential and Shift Forks - Tightening Torques; Transmission Housing and Clutch Housing - Tightening Torques

Manual
Transmission
Audi TT Quick Reference Specication Book • May 2009 63
02Q Installation Position of Shafts and Selector
Rods in Transmission
Component
1 - Input shaft
2 - Output shaft 1st to 4th gears
3 - Output shaft for 5th/6th and reverse gear
4 - Reverse shaft
A - Selector rod for 3rd and 4th gear
B - Selector rod for 1st and 2nd gear
C - Selector rod for 5th and 6th gear
D - Reverse gear shift fork
02Q Input Shaft, Output Shaft (Pinion Shaft),
Differential and Shift Forks – Tightening Torques
Component Nm
Reverse gear shift fork Internal Torx® head bolt 25
Bearing mount nuts 25 plus an
additional 90°
(¼ turn)
Drive ange shaft with spring countersunk bolt 33
Shield for right drive axle 25
02Q Transmission Housing and Clutch Housing –
Tightening Torques
Component Nm
Self-locking socket head cap bolt (always replace) 20
Oil drain plug 30