Why does the stylus skip on my Audio Technica AT-LPW40WN?
If the stylus on your Audio Technica Turntable skips, consider the following: * Adjust the tracking force, especially if it's set too light. * Ensure the anti-skate setting matches the cartridge tracking force. * Check the record for any imperfections. * Remove any excess buildup around the stylus tip.
How to fix a Audio Technica AT-LPW40WN Turntable when the platter doesn't spin?
If the platter on your Audio Technica Turntable isn't spinning, try these solutions: * Connect the AC adapter to the outlet. * Make sure the belt is correctly placed on the platter and the motor pulley. * If the belt is damaged, replace it with a new one.
General| Drive Method | Belt-drive |
|---|---|
| Speeds | 33-1/3 RPM, 45 RPM |
| Motor | DC servo motor |
| Cartridge | AT-VM95E |
| Stylus | 0.3 x 0.7 mil elliptical |
| Replacement Stylus | AT-VMN95E |
| Phono Preamp | Built-in switchable |
| Platter | Aluminum |
| Dimensions | 420.0 mm (16.54") W x 340.0 mm (13.39") D x 116.9 mm (4.6") H |
| Tonearm Type | Straight |
| Output | RCA |
| Power Supply | 100-240V AC, 50/60 Hz |
Critical warnings and cautions for safe operation and handling of the turntable.
Step-by-step instructions for installing the platter and drive belt.
Guides on leveling the unit and assembling the tonearm for proper setup.
Instructions for positioning the turntable and making necessary connections.
Procedures for balancing the tonearm and setting tracking force and anti-skate.
Guides on connecting the turntable to audio equipment and the AC adapter.
To Next Page
