Configuration Note 5. Gateway Configuration
Version 6.8 15 Mediant 1000B
5 Gateway Configuration
The procedures below describe the configuration of AudioCodes’ gateway required for
integration with both the PBX and the Avaya Aura Messaging System.
You can configure the gateway using one of the following methods:
Uploading an ini configuration file (*.ini file) – see Section 5.1
Configuring the gateway via the Web interface – see Section 5.2
5.1 Configuring the ini File
For initial setup and configuration, you can upload an ini file (*.ini) to the AudioCodes
gateway that includes the template ini file settings shown in Appendix A.
To upload an ini file:
1. Create a new text file (e.g., using Microsoft Notepad) with the file extension *.ini.
2. Copy the ini file settings from Appendix A and paste them into the text file.
3. Upload the file to the gateway.
Typically, for interoperability with the deployed PBX interfaces and Avaya Aura Messaging,
it is sufficient that you use this ini file template. However, due to specificity of site
deployment, you may need to modify or define certain parameters (such as IP addresses
and Trunk settings) after uploading the ini file.
5.2 Configuring AudioCodes Gateway
The procedures below provide step-by-step instructions for configuring the AudioCodes
gateway, using the Web interface. Ensure that you configure the gateway according to the
configuration settings displayed in the screenshots provided below.
The instructions describe how to setup Avaya Aura Messaging with the gateway
implementing SIP over TLS with and without SRTP.
Note the following Web interface guidelines:
When making configuration changes for each procedure, ensure that you click the
Submit button to save your changes; unless otherwise instructed.
Some of the changes may require a gateway reset for these changes to take effect.
Therefore, (and to save time), reset the gateway only after you complete all of the
gateway configurations.
These procedures are performed using the gateway's Web-based management tool
(i.e., embedded Web server). Before you begin configuring the gateway, ensure that
the Web interface's Navigation tree is in Advanced menu display mode (i.e., the
Advanced option on the Navigation bar is selected), as shown below:
Figure 5-1: Advanced Mode
To Next Page
Loading...
