Configuration Note 26 Document #: LTRT-12470
Avaya Aura Messaging & Nortel CS1000
5.10 Step 8: Configure Routing
This step describes how to configure routing.
To configure routing:
1. Open the 'Outbound IP Routing Table' page (Configuration tab > VoIP > GW and IP
to IP > Routing > Tel to IP Routing).
2. Configure routing from PBX (Tel) to IP. Route all messages from the PSTN to IP
Group 1.
Figure 5-13: Outbound IP Routing Table
3. Open the 'Inbound IP Routing Table' page (Configuration tab > VoIP > GW and IP to
IP > Routing > IP to Trunk Group Routing).
4. Configure routing from IP to PBX. Route all messages from the IP to Trunk Group 1.
Figure 5-14: Inbound IP Routing Table
5. Click Submit.
To Next Page
Loading...
