Configuration Note 20 Document #: LTRT-12470
Avaya Aura Messaging & Nortel CS1000
5.6 Step 4: Configure the SIP Environment
This step describes how to configure the SIP environment.
To configure the SIP environment:
1. Open the 'SIP General Parameters' page (Configuration tab > VoIP > SIP Definition
> General Parameters).
Figure 5-5: SIP General Settings for TLS
2. It is recommended that you configure the gateway and Avaya Aura Messaging to use
TLS. If you prefer to use TCP, then ensure that you configure the following gateway
settings (in the screen above) for TCP:
To configure the gateway and Avaya Aura Messaging to use TLS:
1. From the SIP Transport Type drop-down list, select TLS.
2. In the SIP TCP Local Port field, enter “5061”.
3. In the SIP Destination Port field, enter “5061”.
4. Click Submit.
To configure the gateway and Avaya Aura Messaging to use TCP:
1. From the SIP Transport Type drop-down list, select TCP.
2. In the SIP TCP Local Port field, enter “5060”.
3. In the SIP Destination Port field, enter “5060”.
4. Click Submit.
To Next Page
Loading...
