Configuration Note 22 Document #: LTRT-12470
Avaya Aura Messaging & Nortel CS1000
5.8 Step 6: Configure Trunk Group
This step describes how to configure the Trunk group.
To configure the Trunk group:
1. Open the 'Trunk Group Table' page (Configuration Tab: VoIP > GW and IP to IP >
Trunk Group > Trunk Group).
Figure 5-7: Trunk Group Table
3. Match the ‘Phone Number’ field with the pilot number of the QSIG trunk.
4. If more than one trunk is used, in the ‘To Trunk’ field, enter the last trunk number (e.g.,
2) pertaining to the Trunk Group and then in the ‘Channel’ field, enter the number of
channels (e.g., 1-48) accordingly.
5. Click Submit.
To Next Page
Loading...
