Version 5.8 81 July 2009
Installation Manual 5. Assigning an IP Address
5. Change the network settings by typing the following:
SCP IP [ip_address] [subnet_mask] [default_gateway]
For example,
SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
The new settings take effect on-the-fly and connectivity to the device is active at the
new IP address.
Note: This command requires you to enter all three network parameters (each
separated by a space).
6. To save the configuration, at the prompt, type SAR, and then press <Enter>; the device
restarts with the new network settings.
7. For Mediant 3000 HA, repeat steps 1 through 6 for the second blade (this is the local,
private IP addresses of the blades).
To Next Page
Loading...
