43
USER'S MANUAL
bit One HD /
This window is active. You can click on the speaker or on the
speaker system to manage each single channel that, once
selected, will be highlighted.
If you keep the CTRL key pressed and click on another channel,
this other channel will be selected and highlighted as well.
LISTENING POSITION VISUAL INDICATOR
This window includes the position indicator (highlighted in
green). Four positions are pre-set: driver, passenger, front
central (passenger driver) and rear central.
The indication acts only and exclusively as reference, allowing
to view the listening point optimized with the digital delay
automated calculation.
If delays are set according to the “driver” position and then you
want to optimize the system also for the “passenger” position,
you need to set the distances again through the specic menu,
as the system does not update them automatically.
If used together with the pre-sets, it is useful to create different
setups according to the different listening positions.
This window displays the names given to the eight output
channels of the bit One HD.
This window is active. You can click on it to manage each
channel which, once selected, will be highlighted.
The software will anyhow only allow you to work on one single
channel and will display the word EDIT in red next to the channel
you can operate on.
This selection ensures that all highlighted channels responses
are displayed
(see section 8.5).
Output channels multiple selection.
If you keep the CTRL key pressed and click on another channel,
this other channel will be selected and highlighted as well.
Multiple channels can be selected by ticking the “Multi Sel” box.
Multiple selection is only allowed for functional groups, except
for the Subwoofer that can be selected with any group.
To act on another channel keeping your selection, click on the
right hand of the desired channel, where the EDIT column is.
E.g.: front Left Mid-Hi with Front Left Woofer with Subwoofer, but not with Rear Left Full or Center Full. If you
want to check the Rear+Subwoofer system electrical response you have to de-select the Front system.
When multiple channels are selected the display will show the electrical response for all channels with a blue
curve/line, highlighting the “active” channel in red and the other channels in grey.
You can also select a channel as shown in the diagram in chapter 8.5.
8.5 SELECT A CHANNEL
8.6 CHANNEL MAP
4
5
8
Remark: the channels highlighted in green
are dedicated to the AD LINK 1 and
AD LINK 2 digital outputs
To Next Page
Loading...
Need help?
General
