To Next Page

To Previous Page

USER'S MANUAL

bit One HD /

ADVANCED MODE

The equalization curve, in this mode, is not xed. It must be

selected through a parametric equalizer. The procedure for

the setup is the same as the one previously explained for the

EASY mode with the further possibility to apply a customized

equalization. The image to the side displays the main

window showing a “customized” equalization.

Reset Dynamic EQ

During the setup the Reset EQ button can be selected to

reset the applied modications and restore the default values.

To conrm the settings and activate the Dynamic Equalizer

while listening click on the X of the PC software window.

At a later stage, besides being enabled and disabled via PC

software, this function can also be enabled/disabled via

DRC MP.

4. Bass Boost: when activated, this function operates on

the sub and woofers channels. By selecting Settings the

parametric equalization pole to be set up can be selected

and the “Q” factor can be changed with the use of a mouse

featuring a rotating nger wheel.

To operate on the parametric equalizer the setup window

can also be used (as shown in the image to the side),

providing a more detailed setting on the following parameters:

1. Operating frequency.

2. Parametric pole gain.

3. Quality factor Q.

To use this function click on the button to the left of the

menu until the orange led lights up. To disable the function

click again on the button until the orange led turns off This

function can be enabled and disabled also via DRC MP.

This window shows whether the bit One HD is properly interfaced with the PC and the DRC MP. It also shows the

Firmware version for the device and the Serial Number

8.13 DEVICE INFO 12

1 2 3

Audison bit One HD User Manual

Questions and Answers: