18
USER'S MANUAL
bit One HD /
1. Turn the bit One HD on.
2. Connect the USB cable located on the appropriate connector on the bit One HD to the USB available on the PC.
To uninstall the bit One HD PC software you can
use the link listed on the menu:
Start / All Programs / bit One HD / uninstall
3. Windows XP: the PC will recognize the bit One HD interface and will automatically install the driver;
Windows Vista: the PC will recognize the bit One HD interface and will automatically install the driver;
Windows 7/8/10: the PC will recognize the bit One HD interface and will automatically install the driver;
4. The peripheral device has been installed correctly and is ready for use.
6.2 DRIVERS INSTALLATION GUIDE FOR WINDOWS XP, VISTA, 7/8/10
6.3 bit One HD SOFTWARE UNINSTALL
Windows XP Windows XP
Windows Vista Windows Vista
Windows 7/8/10 Windows 7/8/10
8. Windows XP: go on and complete the installation procedure, then select CLOSE to exit the installation;
Windows Vista: go on and complete the installation procedure, then select CLOSE to exit the installation;
Windows 7: go on and complete the installation procedure, then select CLOSE to exit the installation;
Windows 8/10: go on and complete the installation procedure, then select CLOSE to exit the installation;
9. The bit One HD PC software is now installed in your system.
WARNING: when connecting a laptop PC via USB cable to the bit One HD while the device is turned on, the laptop has
to work with its own battery, keeping it disconnected from the mains adapter (external power supply).
Once the connection between the laptop PC and the bit One HD is established, you can immediately connect
the computer, if necessary, through the mains adapter.
Remark: the bit One HD uses HID drivers already integrated in Windows. For this reason, they are not included in
the CD and will always install automatically.
6
To Next Page
Loading...
Need help?
General
