AUMA SA 25.1 - Page 4

638.3. Analogue signals (analogue outputs)
659. Commissioning (basic settings)...........................................................................................
659.1. Type of seating: set
669.2. HART address (slave address): set
679.3. Switch compartment: open
679.4. Torque switching: set
689.5. Limit switching: set
689.5.1. End position CLOSED (black section): set
699.5.2. End position OPEN (white section): set
699.6. Intermediate positions: set
709.6.1. Running direction CLOSE (black section): set
709.6.2. Running direction OPEN (white section): set
709.7. Test run
709.7.1. Direction of rotation at mechanical position indicator: check
719.7.2. Direction of rotation at hollow shaft/stem: check
729.7.3. Limit switching: check
729.7.4. Reference operation position feedback: perform
7310. Commissioning (optional equipment settings)...................................................................
7310.1. EWG 01.1 electronic position transmitter
7410.1.1. Measuring range: set
7410.1.2. Current values : adjust
7510.1.3. LED end position signalling: switch on/off
7510.2. Potentiometer
7510.2.1. Potentiometer: set
7610.3. RWG electronic position transmitter
7610.3.1. Measuring range: set
7710.4. Mechanical position indicator: set
7710.5. Switch compartment: close
7911. Corrective action....................................................................................................................
7911.1. Faults during commissioning
7911.2. Fault indications and warning indications
8311.3. Fuses
8311.3.1. Fuses within the actuator controls
8411.3.2. Fuse replacement
8411.3.2.1. Replace fuses F1/F2
8511.3.2.2. Test/replace fuses F3/F4
8511.3.3. Motor protection (thermal monitoring)
8612. Servicing and maintenance...................................................................................................
8612.1. Preventive measures for servicing and safe operation
8712.2. Maintenance
8712.3. Disposal and recycling
8813. Technical data.........................................................................................................................
8813.1. Technical data Multi-turn actuators
9113.2. Technical data Actuator controls
9814. Spare parts.............................................................................................................................
9814.1. Multi-turn actuators SA 25.1 – SA 48.1/SAR 25.1 – SAR 30.1
10014.2. AC 01.2 actuator controls with S electrical connection
10214.3. AC 01.2 actuator controls with SD electrical connection
4
SA 25.1 – SA 48.1/SAR 25.1 – SAR 30.1
Table of contents AC 01.2 Intrusive HART