AUMA SA Series - Industrial Ethernet Cable: Connect; Accessories for Electrical Connection; Actuator Controls on Wall Bracket

To Next Page

To Previous Page

5.4.4. Industrial Ethernet cable: connect

[1] M12 connector for connecting the Industrial Ethernet cable

[2] M12 port

Cable connection

1. Remove protective cap.

2. Connect M12 connector [1] to M12 port for Ethernet cable [2].

3. Tighten cap nut.

5.5. Accessories for electrical connection

5.5.1. Actuator controls on wall bracket

Design Figure 32: Design principle with wall bracket (example)

[1] Wall bracket

[2a] Motor connection/motor control

[2b] Feedback signals from actuator

[3] Electrical connection of wall bracket (XM)

[4] Electrical connection of actuator (XA)

[5] Electrical connection of actuator controls (XK) - customer plug

SA 07.2 – SA 16.2 / SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)

Electrical connection AC 01.2 Non-Intrusive EtherNet/IP

Other manuals for AUMA SA Series